TPB #14 – Camera Axe 5 Shield Assembly

Posted by:

This episode shows the assembly of a Camera Axe 5 Shield. While I’m d decent solderer I’m not that fast. It is sped up 5x. Total assembly time was about 40 minutes. There is a build guide for this kit with a full bill of materials and step by step instructions.

This kit is for sale at the Camera Axe store.

Credits

Music by Dan-O

Continue Reading →
0

TPB #13 – Measuring Camera Shutter Lag with the Camera Axe

Posted by:

This episode show how to measure shutter lag with the Camera Axe. Form more information about shutter lag check out episode #2.

The basic theory is that we trigger both a camera and a flash from the same sensor. We will delay the flash by more each time until we find how long it takes for the shutter to open.

Thanks to Ernie for asking about how to measure shutter lag with the ...

Continue Reading →
5

TPB #12 – Projectile Sensor Setup

Posted by:

This episode discusses how to assemble the projectile sensor and connect it to the Alan Sailer’s Flickr Photostream

  • Music by Dan-O
  • Forum posts about ...
  • Continue Reading →
    1

    TPB #11 – Camera Axe 5 Shield Prototype

    Posted by:

    This episode is an early showing of the Camera Axe 5 Shield. The general plan in the future is that there will be the assembled version of the Camera Axe 5 that will come in a plastic enclosure like past Camera Axes, but there will also be this shield kit that people can assemble themselves.

    The word “shield” is commonly used in the Arduino community to describe a board that plugs into an Arduino to ...

    Continue Reading →
    1